메뉴 닫기

PSpice Bias Point Simulation

Use the following Place Part(P) tools to add power and R/C parts.
Press the Place Ground (G) button on the right.
After confirming that the GND symbol has a 0 mark, press the OK button. (Simulation only ground)
Press the Place Wire(W) button on the right.
Create this circuit.
Click on the provided icon.
Set the analysis type to bias point.
Click the Run PSpice button.
For each node, you can check the voltage, current, and power.

답글 남기기

이메일 주소를 발행하지 않을 것입니다. 필수 항목은 *(으)로 표시합니다